Literature
UMS Mold
Vacuum Units |
Mold Vacuum Units Benefits/Standard Features
Benefits/Standard Features
 
Flat Mounted Side Mounted
UMS
Vacuum
Unit |
Benefits |
| Yes |
Improves molded part quality by reducing: (part burns, voids, short shots, gas entrapment, flash, & mold cleaning) |
| Yes |
Low maintenance |
| Yes |
Easy to install and operate |
| Yes |
Competitively priced |
| Yes |
Evacuation times of less than .3 seconds |
| Yes |
Reduced injection time |
| |
Standard Features |
| Yes |
Begin vacuum at mold position or mold close (via limit switch) |
| Yes |
Fully programmable timers for precise control |
| Yes |
Front panel mounted operator interface |
| Yes |
Positive pressure features: |
| Yes |
- Vacuum release dissipates mold vacuum |
| Yes |
- Air blast to purge vents and aid with part release (blowback) |
| Yes |
- Utilize as a mold sweep (used w/ customer supplied auxiliary parts) |
| Yes |
- Blowback delay for increased versatility |
| Yes |
High power vacuum pump for quick response without storage tank |
| Yes |
Save Energy (use compressed air only when you need vacuum) |
| Yes |
External mounting capabilities |
| Yes |
Intuitive display for easy setup |
| Yes |
Permit injection from integrated vacuum level switches |
Options
• Remote valve (at mold, instantaneous vacuum)
• Custom designed units for extra capacity
• Begin vacuum at mold position or mold close (via SPI)
• Tool mounted vacuum gauge to verify evacuation - ½” I.D. vacuum hose
Technical Specifictions
Venture vacuum pump, 20-25 -inHg potential available vacuum, 50-87 PSI at 21.5 scfm required for vacuum pump, 14x16x8 box with external mounting capabilities.
|
 |